
14.7 How to connect the cables to the batteries
WARNING!
If you are in any doubt, please contact your Sunrise Medical
authorised dealer. For further information please refer to the
technical manual.
Parts in the battery box:•
Supporting plate for wheelchair controller and electric •
modules.
Conical-shaped terminals for batteries with cylindrical •
terminals.
Two installation cables. •
Connect the batteries with the terminals opposing the centre of
the plate to avoid possible contact with it.
WARNING!
Before connecting the battery terminals it is very important to
identify the correct connection for each battery terminal. Failure
to adhere to this will result in the wheelchair not functioning or
a ruptured fuse.
WARNING!
Connect all battery terminals before connecting the plugs.
WARNING!
After connecting battery terminals and connectors ensure all
wiring is tidy and can not get entangled in any moving parts.
NOTE: After connection of the batteries wait 2 minutes
(acquisition time*) before switching on the control system.
This time is required every time the batteries are disconnected.
* Acquisition time – during this period the motor controller
is interrogating the drive parameters from all of the modules
fitted to the chair.
Lift the seat and use the seat stay to secure it. Lift the plastic
cover off the battery box, (Fig.14.12)..
The Front battery has RED to Positive (+) & YELLOW to
negative (-). (Fig.14.13).
The Rear battery has YELLOW to Positive (+) & BLACK to
negative (-). (Fig.14.14).
Connect the RED plugs, (Fig.14.15).
Connect the BLACK plugs< (Fig.14.16).
Connect the WHITE plugs, (Fig.14.17).
Fig. 14.12
Fig. 14.13
Fig. 14.15
Fig. 14.16
Fig. 14.17
Fig. 14.14
Komentáře k této Příručce