Quickie Groove Technické informace Strana 25

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 66
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 24
Quickie Groove 25
.EMS
NOTE: Please refer to Section 7 for details of your hand
controls
6.13.1 Powered adjustable backrest
The backrest can be reclined by operating your control system
VR2 Control:
To recline the backrest angle:
Push one of the actuator buttons that has the seat icon on it
to select actuator mode.
Operate the joystick left or right to select the actuator
required (actuator 1 or actuator 2). Selection is indicated via
the lighting of the red LED adjacent to the desired actuator
button.
Operate the joystick in the forward or rearward direction to
move the recline up or down.
Release the joystick when the desired angle is reached.
To return to drive mode press the actuator button again.
CAUTION!
Once the back is fully reclined or raised do not hold the joystick
in its operating position as this could damage the actuator.
To return to drive mode, press the mode button again.
R-net Control
Please refer to your R-net Owners Manual for details.
WARNING!
Lowering the backrest by an angle of greater than 15° from
vertical alters the balance of your wheelchair. Never exceed
15° of recline when on any gradient or when driving your
wheelchair.
6.13.2 Powered seat lift
The seat can lift up to 30 cm by operating it through your
control system.
VR2 Control:
To operate the powered lift:
WARNING!
Before operating the seat lift function ensure that the immediate
area around the wheelchair is clear of possible obstructions,
(eg wall shelving), and potential hazards, (eg small children
and pets).
Push one of the actuator buttons that has the seat icon on it
to select actuator mode.
Operate the joystick left or right to select the actuator
required (actuator 1 or actuator 2). Selection is indicated
via the lighting of the red LED adjacent to the desired
actuator button.
Operate the joystick in the forward or rearward direction to
move the seat lift up or down.
Release the joystick when the desired height is reached.
To return to drive mode press the actuator button again.
CAUTION!
Once the seat is fully raised or fully down, do not hold the
joystick in its operating position as this could damage the
actuator
R-net Control
Please refer to your R-net Owners Manual for details.
6.13.3 Powered seat tilt
The seat can be tilted by operating your control system.
VR2 Control:
To operate the powered tilt please follow the instructions listed
above in section 6.13.2, but select the actuator button associated
with the Tilt function.
R-net Control
Please refer to your R-net Owners Manual for details.
NOTE: With the seat lift raised the maximum speed is limited
to approximately 10% of its normal value. This is known as
“Creep Mode”.
Raising the seat in combination with other powered seating
options, such as tilt/recline/leg rests, can suspend the normal
drive options, (depending on programming). This is quite
normal and is a safety feature.
To start driving the wheelchair again, bring the seating options
back to their start positions.
Zobrazit stránku 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 65 66

Komentáře k této Příručce

Žádné komentáře