
10.0 Controller Mounts
10.1 General warnings
WARNING!
Do not replace the joystick knob with any unauthorised •
item. It may cause hazardous operation and loss of control
of the chair.
It is important that the joystick boot is replaced if it is torn •
or brittle; failure to do so could cause substance damage to
the controller and unexpected movement of the chair.
Ensure that you always have comfortable access to the •
controls whilst the chair is moving and make sure that the
controller is fixed securely to the chair.
WARNING!
To avoid unexpected or unintentional movement of the
wheelchair and to conserve battery power, it is recommended
that the control system is switched Off when drive or seating
adjustments are not being used.
10.2 Parallel swing-away general warnings, (Fig.10.1)
WARNING!
Before adjusting the swing-away arm, switch off the •
controller to avoid accidental displacement of the
joystick which would cause unwanted movement of your
wheelchair.
Keep your fingers and clothing, etc. clear while operating •
the swing-away mechanism.
Be aware that the width of your chair has increased if the •
swing-away arm is out and you may not get between certain
obstacles.
Do not hang any items on or over the parallel swing-away •
remote assembly as this could damage the swing-away
mechanism.
When transferring to and from the wheelchair do not use •
the remote as a means of support.
Keep fingers, clothing, etc. clear of the swing-away •
mechanism at all times.
Ensure the power is switched off while adjusting the parallel •
swing-away arm.
Only operate the wheelchair at low manoeuvring speed •
when the parallel swing-away is in use. (See “parallel
swing-away” picture on the right).
10.3 Attendant control, (Fig.10.2)
WARNING!
Ensure that you set the speed of the attendant control to a speed
that you can comfortably follow.
Always turn off the power to the controller when leaving the
user in the chair. (See “attendant control” picture below).
FIG.10.2
Fig.10.1
Komentáře k této Příručce