Quickie Pulse Servisní příručka stáhnout pdf (Strana 64)

PULSE 6 SERVICE MANUAL

PAGE 7.15

SEPT 2011SUNRISE MEDICAL

Section 7

Tilt Actuator and Micro-Switch Removal

The following procedures describe the removal of

the tilt actuator and/or the micro-switch assembly

used for the creep speed. Read the full set of

directions prior to performing the task. Some

steps may be eliminated if both items do not need

to be replaced. Reverse the procedures to install

the tilt actuator and/or micro-switch and retest as

necessary.

1. Disconnect the 6-pin connector "A" located on

the rear of the tilt system (ﬁ g. 7.38).

2. Remove the cover over the 6 pin connector

on the rear of the tilt system using a 3 mm Allen

wrench (ﬁ gure 7.15.2).

3. Locate the micro-switch assembly and remove

using a 3 mm Allen wrench (ﬁ g. 7.15.3).

Note: this step may be eliminated if the micro-

switch is to be disconnected and left in place.

Removal Procedures (cont.)

fig. 7.15.1

fig. 7.15.2

fig. 7.15.3

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 70 71 72

Žádné komentáře

Quickie Pulse Servisní příručka Strana 64